Installing Auxiliary Cameras with the RZ41 Vision Hub

Installing Auxiliary Cameras with the RZ41 Vision Hub

The RZ41 AI Vision Hub expands the RoadEazy RZ1 Vehicle Gateway, adding up to four auxiliary cameras per unit. This gives fleets full coverage of blind spots, cargo areas, and equipment zones. For larger setups, two RZ41s can be linked to a single RZ1, supporting up to eight cameras total.

The RZ41 hub mounts discreetly under the dashboard, with LED indicators confirming power and video signals once installation is complete.

Installation Steps

  1. Connect Cameras

    • Plug each auxiliary camera into the on of the four Video In ports on the RZ41.

    • Ensure connectors click and lock in place. For third-party cameras, adapters or cables may be required (not included in the RZ41 package).

  2. Connect to the RZ1 Vehicle Gateway

    • Power off the RZ1 before making connections.

    • Plug the RZ41 USB cable into the RZ1 USB port and tighten the safety screw.

    • Unplug the RZ1 power cable, then: Connect the RZ41 power cable into the RZ1.

    • Plug the vehicle’s original power cable into the female socket on the RZ41 power cable.

    WarningWarning
    Power first. Always disconnect vehicle power and the RZ1 before connecting or removing the RZ41 to prevent damage.

  3. Mount the RZ41

    • Install the RZ41 under the dashboard and behind the diagnostic port.

    • Secure with provided zip ties. 

    WarningWarning
    Do not place the RZ41 on top of the RZ1 or block airflow around the device, as this may cause overheating and system malfunction.
    IdeaTip
    Test before mounting. Connect and power on all cameras before permanently mounting the RZ41, to confirm each video feed is working.

  4. Power & Verify

    • Turn on vehicle ignition.

    • Check that LED indicators for all connected cameras turn green, confirming power and video signal.

    5. IdeaTip
    Label camera ports; mark each connected camera cable during installation to simplify troubleshooting later.
    NotesNote
    Auxiliary cameras must be enabled and configured prior to use.

Safety Guidelines

  1. Professional installation is strongly recommended.

  2. Mount securely without blocking driver view, airbags, or vehicle controls.

  3. Route cables safely to avoid pedals, moving parts, heat, or pinch points.

  4. Use only approved cables/adapters - do not cut or modify vehicle wiring.

  5. Follow local laws on video/audio recording.

  6. Inspect regularly to confirm cables and mounts remain secure.

  7. Never adjust while driving; pull over before making changes.

  8. Do not modify or repair the RZ41; unauthorized changes void warranty.

    • Related Articles

    • RZ1 Installation Troubleshooting

      During the installation process, the system performs four main verification tests to ensure proper device functionality: Power Connection, Mobile Network Connection, GPS Connection, and Cloud Connectivity. If any of these tests fail, it may prevent ...

    • RoadEazy RZ1 Installation (Video)

    • Installation, Safety, and Maintenance Guidelines

      Professional Installation Recommended For optimal performance and compliance with regulations, it is strongly advised to have the device professionally installed. Mounting Location Install the device in a location that does not obstruct the driver's ...

    • How to Mount and Wire the RZ1 Device (OBD)

      The RoadEazy RZ1 system is designed for a simple and straightforward installation process. Follow these step-by-step instructions to properly install the RZ1 Vehicle Hub and Camera. Vehicle Hub Installation: Locate the Vehicle's Diagnostic Port ...

    • MiTAC K220 Installation Guide

      This article will show you everything you need to install the K220, and how to do so. Package Contents: At a Glance: Installation Steps: Find the right spot to install the camera. Do not block your view of the road or the rear view mirror. Use the ...