How to Do a Pin Reset on My RZ1
Pin Reset for an RZ1
Warning
Do not do the below steps unless instructed to by a tech or an article.
- Unscrew the latch on the bottom of the RZ1 box with a Philips head screwdriver.
- Locate the RST port above the SIM slot, to the right of the SD card slot.
- Press a paper clip or thumb tack into the RST port and release.
- Close the compartment and retighten the screw.
Related Articles
Reset the Surfsight Dashcam - Pin Reset
Reset the Surfsight Dashcam - Pin Reset Locate the Reset button on the side of the dashcam by removing the SIM/SD cover on the side of the camera. Press the Reset Button until the camera screen goes black (a paperclip or pushpin will work) — then ...Red Button Reset
A red button reset is similar to rebooting your PC. This resolves a great deal of issues. Note This is only available on newer firmware (2.4.12 or later). If the camera has not had a firmware update or has been offline since approximately May 2025 or ...How to Factory Reset Your Dash Cam
This guide will show you how to reset your camera for troubleshooting purposes. Factory Resetting the Dash Cam: First, wake up the dash cam and put in the default PIN of 3333, or use your own PIN if you have already created one. Go to the Settings ...How to Replace Your RoadEazy RZ1 SD Card (Video)
How to Replace Your RoadEazy SD Card (RZ1)Lytx One (Formarly RoadEazy RZ1) Camera and Security
Common Questions 1. Where are the RZ1 cameras and chips manufactured? The devices are manufactured in Vietnam and incorporate U.S.-headquartered components: • Telit PLS83-X Certified 4G Module with GPS and AGPS, developed by Telit (Headquarters: ...