Understanding LED Statuses

Understanding LED Statuses

RZ1 Vehicle Hub’s LEDs

POWER LED

  • Green: The hub is connected to power and is in either an active or standby state.

GNSS LED (GPS Status)

  • Off: The hub is in standby mode, and the GNSS and CELL LEDs are inactive.
  • Red: The GNSS is active but has not acquired any satellites.
  • Blinking Red: The hub is attempting to acquire satellites but has not yet achieved a location fix.
  • Green: The GNSS has successfully acquired satellites and a location fix.

CELL LED (Network Connectivity)

  • Off: The hub is in standby mode, with no active network connection (GNSS LED is also off).
  • Red: No SIM card is detected in the hub.
  • Blinking Red: The hub is attempting to connect to a mobile network.
  • Blinking Green: The hub is connected to the mobile network but not yet to the Roadeazy cloud.
  • Green: The hub is fully connected to both the mobile network and the Roadeazy cloud.

 

 

RZ1 Camera System LEDs

Power LED (Green)

  • On: The camera is powered and in an active state.
  • Off: The camera is in standby mode or powered off.

Event LED (Red)

  • Blinking: A visual event alert is active, indicating that the camera has detected and recorded an event.

    • Related Articles

    • Understanding the Dash Cam

      The dash cam has lenses on each side, allowing it to capture video of the driver and the road at the same time. The in-cab lens allows you to: Understand and benefit from driving alerts. Manually trigger an event. Key Components: Road-Facing Camera - ...

    • Installation, Safety, and Maintenance Guidelines

      Professional Installation Recommended For optimal performance and compliance with regulations, it is strongly advised to have the device professionally installed. Mounting Location Install the device in a location that does not obstruct the driver's ...

    • RZ1 Installation Troubleshooting

      During the installation process, the system performs four main verification tests to ensure proper device functionality: Power Connection, Mobile Network Connection, GPS Connection, and Cloud Connectivity. If any of these tests fail, it may prevent ...

    • How to Mount and Wire the RZ1 Device

      The RoadEazy RZ1 system is designed for a simple and straightforward installation process. Follow these step-by-step instructions to properly install the RZ1 Vehicle Hub and Camera. Vehicle Hub Installation: Locate the Vehicle's Diagnostic Port ...

    • Understanding the Dash Cam

      The dash cam has lenses on each side, allowing it to capture video of the driver and the road at the same time. The in-cab lens has two lenses with two separate sensors, one is RGB, designed for the day, and the other is IR (infrared), which allows ...